HTS 3701.30.00Photographic plates and film in the flat, sensitized, unexposed, of any material other than paper, paperboard or textiles; instant print film in the flat, sensitized, unexposed, whether or not in packs:Other plates and film, with any side exceeding 255 mm

The steel, aluminum and copper tariff doesn't apply to “Articles provided for in subdivision (c) of U.S. note 16 to this subchapter that do not contain any aluminum, steel, or copper” (HTS 9903.82.01).

The steel, aluminum and copper tariff doesn't apply to “Except for articles classifiable in chapters 72, 73, 74 or 76, articles where the weight of the applicable metal is less than 15 percent of the weight of the imported article” (HTS 9903.82.03).

No forced-labor tariff here: products covered by the steel, aluminum and copper tariff (HTS 9903.82.09) are exempt from it.

The steel, aluminum and copper tariff instead adds 10% where this applies: “For derivative articles provided for in subdivisions (c)(ii), (vi), and (ix), at least 85 percent of the aluminum content of the article must be composed of aluminum that was smelted and cast in the United States. For derivative articles provided for in subdivisions (c)(iv), (vii), (x) and (xi), at least 85 percent of the steel content of the article must be composed of steel that was melted and poured in the United States. For articles provided for in subdivision (c)(viii), at least 85 percent of the copper content of the article must be composed of copper that was smelt and cast in the United States. These requirements are cumulative such that a derivative article in more than one subdivision must satisfy each requirement” (HTS 9903.82.06).

The steel, aluminum and copper tariff instead adds 200% where this applies: “where any amount of primary aluminum used in the manufacture of the derivative articles is smelted in Russia, or where the derivative aluminum articles are cast in Russia” (HTS 9903.85.68).